|
Posts: 35
| Alright, so let me preface this saying that this is my first boat. Ergo, I have never dealt with this before.
Anyways, I had a hub self implode on my trip home fourth of July weekend. Pulled the old hubs off, replaced them with the same size that were on there. Then I noticed that there is a lip on the spindle that stops the hub from sitting flush against the back plate.
I know the heavier duty hubs have a larger bearing in the backside. Is that the type of hub that was supposed to go on here? Or, is this correct. The old hubs that I pulled off must of been the same way (I didnt really look before pulling them off).
Thanks guys
(rsz_20160716_092511.jpg)
Attachments
----------------
 rsz_20160716_092511.jpg (148KB - 396 downloads)
| |
|
