Posts: 1150
Location: Minnesota. | jerken jimi - 8/13/2014 4:14 PM
Not so much the nick but being bent will throw off the balance of the prop and,like losing a wheel weight on a car tire will make the car shake,the bent prop will make the motor shake, not good for shaft seal ect... Go slow depending on the bend, best to wait for the new one...MY 2 cents..
What Jimi said. I'd err on the side of caution if it were mine and wait. Don't need to put added stress on the bearings, assuming you might...I woundn't chance that. |
