|
Posts: 865
| I had the same problem but Fixed it in 5 minutes, Simply make sure you put the rod holders in the correct position, where you can set your rods deep in the water and then out of the water if wanted. Now carefully remove the thumb screw and you will see a hole in the clamp base. Now Simply use a drill and drill one correct size hole threw one side of the s/s tube and use a aluminum rivet. It is a easy fix and it will never slip again, Did it months ago and it is 100% effective. Forget the tape the rubber and everything else. It doe not weaken the rails in any way....Mike Sr. | |
|
