|
Posts: 42
| Jim,
Did you just buy this rig or have you had this problem from start? What hole is the motor mounted to the boat, count from the top hole? Mine is the fifth hole from the top. I have had no porpose problems at that speed or rpm, fully loaded or empty.Do you have the TRIM TAB STILL ON THE MOTOR? Is this problem with a full tank of gas or does it porpose with a half tank, quarter tank? I am going to have to disagree that a three blade prop is better than a four. A four blade is going to get you out of the hole faster and have more top end and control factor at top speed. Think about it, you are always going to have another blade in the water to give you more push and torque. If a three blade is better than why do they run four blade props on a mastercraft and run the same in race boats? People comlain about the four blade props because of there price until they own one.
Edited by glog 8/1/2011 8:09 PM
| |
|
