Muskie Discussion Forums

Forums | Calendars | Albums | Quotes | Language | Blogs Search | Statistics | User Listing
You are logged in as a guest. ( logon | register )
Posting a reply to: Re: Humminbird side imaging with esox mag

Back
Muskie Fishing -> Muskie Boats and Motors
Guest name
Subject
Message

Emoticons
HTML: Yes
Anonymous: Yes
MBBS Code: Yes


 Disable HTML
Post anonymously
Enable emoticons



hi


You are replying to:
Targa01
Posted 7/5/2011 9:37 PM (#505849 - in reply to #505842)
Subject: Re: Humminbird side imaging with esox mag





Posts: 742


Location: Grand Rapids MN		I would guess your other transducer is still in the way since it is lower than the HB transducer. From what I've read on HB SI people usually mount the SI unit as close to the center of the boat hull and as low as possible. But this usually affects the 2D sonar quality so they will add a secondary transducer for the 2D but move it further out to the side and higher up or it will be in the way. With out drilling more holes I would say try swapping locations of your two transducer. This might allow you to see the full range. Usually something partially in the way will only 'cloud' the image and not entirely block it but its hard to say for sure.

Good luck with it.

Edited by Targa01 7/5/2011 9:40 PM

(Delete all cookies set by this site)