Posts: 3508
Location: Elk River, Minnesota | Hiya,
Something you can check is the trailing edge of the hull right by the transom. What you may be able to do is peen that back edge up a bit evenly on both sides which will allow the bow to come up easier. This would allow the bow to ride higher, to get less wetted surface.
My rig had to have the opposite done, where the manufacturer peened the rear up too much which didn't allow me to trim up at all. So..they went the opposite way, then I adjusted from there. There will be some people who would be a bit heistant to bang a hammer on their boat, but if one takes their time, it can be done and adjusted well.
I think TJ and I will agree to disagree on this one...
Steve |
