Posts: 2323
Location: Stevens Point, WI | What your going to have to do is, or at least how I have done it in the past or helped rigged friends boats is you run the cord up the shaft as far as you can to where the motor is still in the water. You want to use electrical tape to tape the cord to the shaft. Then you will have to leave the cord some what loose through the middle or the shaft, you will then want to tape somewhere else along the shaft so it's not flopping everywhere. You best bet is to just play around with it a little to figure out how it will work best for you. I've seen it done a couple different ways. You can also use zip ties also, they might allow you to move them up and down on the shaft a little so it's not so permenantly taped to the shaft. Hope this helps, let me know if you have any questions. |