Muskie Discussion Forums

Forums | Calendars | Albums | Quotes | Language | Blogs Search | Statistics | User Listing
You are logged in as a guest. ( logon | register )
Posting a reply to: RE: replacing trailer bearings

Back
Muskie Fishing -> Muskie Boats and Motors
Guest name
Subject
Message

Emoticons
HTML: Yes
Anonymous: Yes
MBBS Code: Yes


 Disable HTML
Post anonymously
Enable emoticons



hi


You are replying to:
Running_Hot
Posted 8/4/2005 9:32 PM (#155788 - in reply to #155722)
Subject: RE: replacing trailer bearings




Posts: 326


Location: Plainfield IL		http://www.bassboatcentral.com/sttipsbb.htm

I have taken many sets of races out of hubs. I have a few screw drivers that I have ground down on a bench grinder and bent so the fit from the back of the hub and tap out the race. Do not use a punch to install the new races. Take your old races and put them on the grinding wheel and grind them down a bit. Stick a screw driver through the middle of the race and let them roll on the wheel. You can use the old race that is ground down to tap the new race in. The old race will fall out of the hub when you are done.

Daryl

(Delete all cookies set by this site)