Posts: 550
Location: So. Illinois | ok Muskie-1st board personnel, looking for suggestions and ideas how to outfit my 19' run-about with a bow-mount trolling motor. I have been using the family boat for muskie fishing now for three years and I am tired of not having any boat control. I am building a casting deck for the front. I will be removing the front cushions and put down a carpeted, sealed floor with a seat fixture so I can stand/sit comfortably and fish. I plan on using good quality plywood (thick) and make it so it just fits in the bow. I plan on making it removable so I can still use the boat for those days when the kids want to tube. The question I have is, is it possible to add a bow mount trolling motor? The area in the bow looks small and I don't have a clue on motors or if there are any made with a small installation foot print. I was thinking I could build a platform up front raised above the running lights (by using posts) so that I can enlarge the mounting surface for the motor. I expect to need a large capacity motor (72lbs or higher) with a 54" shaft. I plan on putting the batteries under the seats or on the floor. Looking for feedback if my brain-child is workable or if I should spare the expense and not worry about it. Options to get a different boat are out at this time. Photos below....
Jerry
Edited by AFChief 7/8/2005 6:38 PM
Attachments
----------------
 Bow.JPG (135KB - 546 downloads)
Bow 2.JPG (135KB - 383 downloads)
|
