Posts: 317
Location: Grafton, WI | As appealing as that sounds chuckinwood, I would probably pass. This is the second boat I have done a complete refurb on, and hopefully the last.
lambeau - here's a closer look at the back deck. First thing I did was figure out the size of the deck and cut that from 3/4" marine plywood. Next, measure down just over 3/4" (just over to compensate for carpet height) to figure out where to put the bracing, in my case, I used 1x2 anchored to the sides. Then, I cut another piece of plywood for the face of the deck. I used a couple L-brackets to secure it in place. I left the pedestal and post back there to give the deck more support. Finally, I added hinges to the back of the deck - going from the 1x2 to the top of the deck.
Hope that makes sense
Attachments
----------------
 rear_deck_1.jpg (85KB - 359 downloads)
rear_deck_2.jpg (90KB - 366 downloads)
|
