Post a message

Muskie Discussion Forums

Search | Statistics | User Listing

You are logged in as a guest. ( logon | register )

Posting a reply to: Re: Terrova

Muskie Fishing -> Muskie Boats and Motors

Guest name

Subject

Message

Emoticons

HTML: Yes
Anonymous: Yes
MBBS Code: Yes

Disable HTML
Post anonymously
Enable emoticons

You are replying to:

bturg

Posted 3/4/2023 11:39 PM (#1018623 - in reply to #1018529)
Subject: Re: Terrova

Posts: 714

miket55 - 3/2/2023 3:47 PM

Mojo1269 - 3/1/2023 9:56 PM

Not sure if its archived electronically but Bturg did this and had it in one of his articles in the print Musky Hunter Magazine I believe. Works great... and unlike fishing fish a jig ripper it wont break on a big fish.. :-)

Thanks, I found the article. Apparently it was invented to keep his TM head from bouncing while moving, and a side benefit was discovered.. I might try that.. It's in the April/May 2018 issue on pg. 12..

I mounted mine on the vertical axis. For the purpose of limiting head bounce but for sure is a good handle as well. Screws right on then use a dowl rod inside the handle to adjust for length. Add a rubber table leg cap to the end and your in business.