sworrall - 8/9/2018 9:01 PM

What does the saddle on the trailer end of the transom saver attach to?
[I had to cut the transom saver down about 10 inches to maintain an average towing height on the 90 over the roller on the back of the trailer. I removed the "stud" end of the transom saver and welded a 12 in piece of 1 in flat stock to it. You must drill a center hole in the flat stock large enough to fit the cut of stud. after welding the flat stock to the stud it is easy to bund it into the "U" shape needed to fit the roller. After you get the fit simply cut off the extra stock on each end. The whole modification to me 30 min. To accommodate the saver for the kicker I simply drilled two 1/2 in holes. One on top the other in the trailer cross bar. I've also done this to accommodate the transom saver for the main motor. By the photo u posted the two 1/2 in holes would work. You may need to lower or replace the center light bar. Two red marker lights, one on each side of the drilled hole for the toter would work well and easy to do. Hope this helps/QUOTE]