Muskie Discussion Forums

Forums | Calendars | Albums | Quotes | Language | Blogs Search | Statistics | User Listing
You are logged in as a guest. ( logon | register )
Posting a reply to: Re: Suggestions...

Back
Muskie Fishing -> Muskie Boats and Motors
Guest name
Subject
Message

Emoticons
HTML: Yes
Anonymous: Yes
MBBS Code: Yes


Disable HTML
Post anonymously
Enable emoticons



hi


You are replying to:
Jerry Newman
Posted 9/8/2016 11:31 AM (#829769 - in reply to #829718)
Subject: Re: Suggestions...




Location: 31
It's vital to the way I fish to be able to easily rotate a rod holder in and out of the water to remove the tremendous pressure that's created with a rod tip buried 5-6’ under the surface at 4 MPH. Like Todd mentioned; even the pressure created with his big boards can make it difficult to get the rod back in the holder. The best/easiest way that I’ve found is to set the rod in the holder while the line is still paying out, or pull the rod several feet forward to remove the pressure before dropping it in the holder.

Also, if you're running a typical 6 line spread and your buddy is pulling/checking the outside board rod while leaving the inside board rod in place, you can turn the boat away from the board for a few seconds to create a better angle between the boat and board to wind it in. Bringing in the entire side in my boat to check the outside board for weeds is unacceptable.

I’ve trolled past plenty of other boats and watched them needlessly fight these situations when there are easier/less frustrating ways to get the job done faster.



Zoom - | Zoom 100% | Zoom + | Expand / Contract | Open New window
Click to expand / contract the width of this image
(Prop wash trolling.jpg)



Attachments
----------------
Attachments Prop wash trolling.jpg (24KB - 393 downloads)

(Delete all cookies set by this site)