Posts: 688
Location: Already Gone | I also have the slide controls on a 96...took some time on the water experimenting and figuring these out. Like Nick said, I would slide them to empty for now, install new pumps, and then work the issues out on the water. If not, buy a couple of plugs as mentioned.
I found my pumps under the floor, center forward. There should be a smaller carpeted floor panel, just remove the screws and pry it up. My pumps were a snap to change out. You will also be able to see those slide valve cables in the same area as the pumps...just to be sure the slides are working correctly.
It's a good system once you figure it out. |
