Posts: 136
| Clint - 3/10/2013 6:45 PM
Run it down the shaft and over the pivot, tape the cord on top and bottom of shaft. The shaft will still slide thru, make sure to run the transducer cord thru the coils on the cord of your motor. It will look much cleaner
+1 what clint said....I ran one of these for years with a transducer mounted on it, tie the cable just under the trolling motor head, run through the coils and out to transducer. Leave slack to allow deploying trolling motor and all should be good. Only thing to watch was I only had enough slack to turn head once, so had to keep an eye on not turning motor head more than once and pulling the cable. |
