Location: 31 | Cowboyhannah - 11/1/2012 8:48 PM
Okay, yeah I thought about disconnecting and dropping in the splash well so the line is there for future use, what would the procedure be to seal off that line?
I've never had a kicker motor without a quick connect, unless it's leaking now it shouldn't leak in the future so once you unplug it from the motor its already sealed off plenty good.
Otherwise, you could use an appropriate sized bolt with the same 3/8" hose clamp.
Addendum: After further review... no points awarded for this last post and you should probably consider removing that entire rubber line if you run gas with ethanol.
Edited by Jerry Newman 11/7/2012 9:33 AM
|
