Post a message

Muskie Discussion Forums

Search | Statistics | User Listing

You are logged in as a guest. ( logon | register )

Posting a reply to: RE: Lowrance HDS-7 Gen2 ??

Muskie Fishing -> Muskie Boats and Motors

Guest name

Subject

Message

Emoticons

[QUOTE]Jerry Newman - 10/15/2012  9:12 PM

[QUOTE]pitch'n - 10/15/2012  7:42 PM

Finaly got an up grade from my 2006 Globalmap 3600C-igps, Went with the HDS-7 Gen2..One of the reason I went that route is that I was told that they will use the older lakemaster promaps SD cards, as I have 4 of them now and wanted to use them. Well I was out on Mille Lacs this last weekend and put my 2010 Mn. card in and all of the contour lines and depth feature's were on the screen, but none of the hazard marker pins would show up. On the old unit with the same chip they would show all of the pins. So I put in a 2006 card in and the HDS showed all of the pins as they should be..But I want to run the"10 chip as it shows way more detail.Ive looked in the manual and made sure everything is checked to show,,I've run out of ideas...Any help out there??[/QUOTE]

You could put the 2006 card in and drop icons on the pins, then run your 10. Obviously not the kind of help you're looking for but it'll get the job done. Good luck![/QUOTE]

HTML: Yes
Anonymous: Yes
MBBS Code: Yes

Disable HTML
Post anonymously
Enable emoticons

You are replying to:

Jerry Newman

Posted 10/15/2012 9:12 PM (#591124 - in reply to #591086)
Subject: RE: Lowrance HDS-7 Gen2 ??

Location: 31

pitch'n - 10/15/2012 7:42 PM

Finaly got an up grade from my 2006 Globalmap 3600C-igps, Went with the HDS-7 Gen2..One of the reason I went that route is that I was told that they will use the older lakemaster promaps SD cards, as I have 4 of them now and wanted to use them. Well I was out on Mille Lacs this last weekend and put my 2010 Mn. card in and all of the contour lines and depth feature's were on the screen, but none of the hazard marker pins would show up. On the old unit with the same chip they would show all of the pins. So I put in a 2006 card in and the HDS showed all of the pins as they should be..But I want to run the"10 chip as it shows way more detail.Ive looked in the manual and made sure everything is checked to show,,I've run out of ideas...Any help out there??

You could put the 2006 card in and drop icons on the pins, then run your 10. Obviously not the kind of help you're looking for but it'll get the job done. Good luck!