Posts: 2323
Location: Stevens Point, WI | Make sure all screws in your marinco plug are tightened down, even the ones for the 12 volt slots. This sounds very typical of not having all the screws tight which woud not allow current to flow through the plug right. I've had this happen a few times and it was those screws.
Also, a Terrova will not run unless its in the down position. The motor has to be deployed. The tester will light up but the prop won't run when stowed FYI.
Edited by TJ DeVoe 7/8/2012 11:55 PM
|
