Posts: 1453
Location: Kronenwetter, WI | I have a trollmaster pro2 system...was installed on 05 Ranger in 07. Has the dial, not digital. When I power on the hand held unit, it powers up fine, the idle button light works as well. However, there was no response from my servo motor, so the throttle obviously did not change either. Ordered and plugged in a new servo motor confident that was the issue, but no. The new servo does not respond either.
I'm wondering if there may be a fuse somewhere that I need to check, but not sure where to look. The unit does not appear to be wired into the fuse board, it appears that the wires run directly to the motor, so I'm not sure where to find a fuse if there even is one. The install was done at the marina where I purchased my T-8.
Any pointers or thoughts and what to try next would be appreciated.
Thanks,
|
