Post a message

Muskie Discussion Forums

Search | Statistics | User Listing

You are logged in as a guest. ( logon | register )

Posting a reply to: Re: Anyone know how to make or where to buy one of these?

Muskie Fishing -> Muskie Boats and Motors

Guest name

Subject

Message

Emoticons

HTML: Yes
Anonymous: Yes
MBBS Code: Yes

Disable HTML
Post anonymously
Enable emoticons

You are replying to:

71mercman

Posted 9/28/2011 7:47 AM (#518523 - in reply to #518464)
Subject: Re: Anyone know how to make or where to buy one of these?

Location: Altoona IA

Can't get your link to refer to what you are needing but I assume it is a manual motor lift (large handle). This is the best option and can be bought at places like Bass Pro, Cabela's etc. Another option is a jack plate. Normally these are for mouning a long shaft on a short shaft transom (raising motor). There are adjustable and non-adjustable. You could use an adjustable plate and drill your own holes slightly lower and use the lowest setting. On the non-adjustable sometimes you can flip them upside down. Normally they have a 4" setback and could be used with a clamp type motor. However, in either case you need to have clearance from from the top and back of the transom for clamps, controls, turning etc.