Post a message

Muskie Discussion Forums

Search | Statistics | User Listing

You are logged in as a guest. ( logon | register )

Posting a reply to: Re: 24 volt system info

Muskie Fishing -> Muskie Boats and Motors

You are replying to:

Muskie Bob

Posted 4/25/2010 8:54 PM (#437477 - in reply to #437357)
Subject: Re: 24 volt system info

Posts: 572

If you bought a new trolling motor, the requirements for a breaker switch should be listed. If not, I'd call a marine dealer and ask them. I'd go with the breaker switch rather than the inline fuse. I believe Minnkota recommended a 60 amp circuit breaker switch. The dealer I talked to thought a 50 amp with a manual reset would work just fine. It was small and fairly inexpense.

I put the breaker switch up front just behind where I plug the trolling motor in. It is directly behind the panel on the red wire for the trolling motor plug in....I hope that makes sense.

Edited by Muskie Bob 4/25/2010 9:01 PM