Posts: 2687
Location: Hayward, WI | Easy to put them on. I like to hold a 2x4 or some other board over the buddy and hit the board with a hammer. Put it in so it's square to the hub, and gently tap it in. When tapping it in, make sure it stays straight and that you aren't tapping one side in too much more than the other. When it's seated or nearly seated then you can hammer on it a little more (still with the board between the bearing buddy and the hammer).
Pretty easy to see how they go in when you start doing it. Good luck!
curleytail
Edited by curleytail 6/5/2009 12:37 PM
|
