Posts: 3508
Location: Elk River, Minnesota | Hiya,
All you need to do is take off the dust cap and install the bearing buddies by hammering them in (evenly) place. Nothing much to it. Once installed, you can add grease through the zerk when you get home... Nothing to be too concerned with to do.
Only thing I would consider checking while doing so is to jack up the tire and wiggle it back and forth. If it wiggles a bit, the castle nut Should be tightened and the cotter pin replaced. Although if it is a short ride home, I'd hold off on everything and just do a bearing job so you know it's done right... Then you are good to go.
Steve |
