Posts: 73
Location: Indiana | Are you talking about shining up the aluminum surfaces? I used some marine aluminum polish on mine. It's a paste that you work in like a rubbing compound. You basically apply and buff until it shines again. I used a pad applicator around the hard to reach places on the boat, really putting some elbow grease into it. Then I used a drill with a buffing pad attachment on the rest. Then I went over the whole thing by hand again. After that was finished, I used aluminum protector stuff and buffed that in as well. It took some time, and lots of work, but it took 16 years of oxidation off my boat...enough so I could see my reflection in it. Of course, it's been a couple years and needs a slight once over again...not nearly what it was like before though.
As for the sticker sections, go with what the guys said above.
Edited by Halfpint 4/14/2009 1:25 PM
|
