Posts: 43
Location: Roch NY | +1 on experimenting. keep in mind that depending on the characteristics of the two props you may find that the new one may work best at the height you have it at or even lower. some are surface piercing and some are best a little deeper.
what hasn't been mentioned is don't be surprized if you find that it is already set up properly and in fact need a lower pitched prop to raise the rpm. 1 inch pitch change equals about 200 rpm.
jack plates are a good way to facilitate making these changes if your rig will support it. most can take at least a 6in plate. will also give the prop more leverage to lift the bow and because it puts the prop further back and in cleaner water, it allows you to run the prop generally an inch higher. make sure to check with those that have experience setting up your particular boat before adding a plate to see if your boat would benefit. |
