Muskie Discussion Forums

Forums | Calendars | Albums | Quotes | Language | Blogs Search | Statistics | User Listing
You are logged in as a guest. ( logon | register )
Posting a reply to: Re: How To - installing a rubber "no slip" step pad.

Back
Muskie Fishing -> Muskie Boats and Motors
Guest name
Subject
Message

Emoticons
HTML: Yes
Anonymous: Yes
MBBS Code: Yes


 Disable HTML
Post anonymously
Enable emoticons



hi


You are replying to:
PANTLEGGER
Posted 3/11/2008 7:19 AM (#306681 - in reply to #306499)
Subject: Re: How To - installing a rubber "no slip" step pad.




Posts: 176


Location: Tomahawk, WI		Jono, I used rubbing alcohol to clean before applying the matting. Apply matting on flat surfaces only (works great). I learned the hard way, do not go over curved areas, the adhesive on the rubber matting is not very good and will peel up. Also, if i was to do it over again, i would remove the trolling motor first and than cover the whole front end like the newer models.

(Delete all cookies set by this site)