Posts: 3518
Location: north central wisconsin | I made the same swap and also couldn't find a conversion plate that would work, and really didn't want a quick release plate anyhow. So, I taped the bottoms of the old holes with electrical tape, then filled the holes with good silicon(you could use Marine Tex if worried), then put the rubber diamond matting over the whole bow cap, this after redrilling the holes in the proper place and poking the holes in the diamond matting. Should now be water tight, and I have the diamond matting on the cap that I liked on other rigs(great grip and gell coat protection for stepping in and out).
Edited by Reef Hawg 3/6/2008 9:54 AM
Attachments
----------------
 1155.jpg (125KB - 118 downloads)
|
