Muskie Discussion Forums

Forums | Calendars | Albums | Quotes | Language | Blogs Search | Statistics | User Listing
You are logged in as a guest. ( logon | register )
Posting a reply to: RE: My poor Gambler

Back
Muskie Fishing -> Muskie Boats and Motors
Guest name
Subject
Message

Emoticons
HTML: Yes
Anonymous: Yes
MBBS Code: Yes


Disable HTML
Post anonymously
Enable emoticons



hi


You are replying to:
lonewolf
Posted 7/28/2006 12:01 PM (#202626 - in reply to #202608)
Subject: RE: My poor Gambler




Posts: 21


Mikie,
If the repair shop you took it to is good, it can be repaired, usually by cutting out the bent axle spindle, (the shiny part that the bearings ride on), and welding in a new spindle. The tricky part is getting the two spindles perfectly straight. It certainly can be done, but unless the axle is something special, the price to replace the axle vs. repair is usually not much different. Most axles, leaf or torsion are commercially available in the $300-$400 range for a 3500lb setup. The repair job I described should not take more than 4 hours, or about $200 in labor, plus a $30 spindle, and $30 in bearings/seals. I have seen it done both ways. You will know almost immediatly if the repair job was done correctly. Watch for abnormal tire wear on the repaired side. This is the clearest indicator of an spindle slightly toe'd out. If this happens, don't despair. Take it back to the repair shop and the tech will heat and tweak it a smidge.

Good Luck
Lonewolf
Back in School at 30 ugh

(Delete all cookies set by this site)