|
|
Posts: 73
| Howdy, just lookin for some feedback, and pros and cons on shoot thru hull transducers. I'd really just being using it for high speed/on plane readings, but how well do they read if used for fishing, if needed. Thx ahead of time! |
|
| |
|
Posts: 228
| Mine works great on my Ranger Reata 1850VS!! Factory installed new and I have replaced it since!!
Bob |
|
| |
|
Posts: 1209
| Same experience in my Nitro. |
|
| |
|
Location: Northern Illinois | They work great have one on my 621, no issues. |
|
| |
|
Posts: 1126
Location: Minnesota. | Used 'em on two Rangers, a '97 681 VS and now on my 2012 Z118....zero issues! |
|
| |
|
Posts: 73
| Awesome, thanks for the great responses guys, much appreciated! Sounds like a done deal for me. |
|
| |
|
Location: Athens, Ohio | Sooo, are you going to install it or have it installed? One of the worst days I've had was trying to convince myself that it is perfectly OK to take a hole saw at the end of an electric drill and bore a wee-bit-larger hole in the floor of my boat so that the transducer would fit. I had to be sedated afterwards, but it worked out.
Next trick, then is to be sure you get the epoxy resin in the hole with no bobbles when you lay the transducer in. After than, covering the unit with the resin was pretty easy. Good luck, m |
|
| |
|
Location: Northern Illinois | You don't have to drill any holes in the bottom of the boat for a shoot thru transducer... The key word shoot thru hull transducer. all you do is clean the surface with sandpaper dry it really good and epoxy the transducer in the correct manor that the instructions state. |
|
| |
|
Posts: 1126
Location: Minnesota. | mikie - 3/5/2020 6:37 AM
Sooo, are you going to install it or have it installed? One of the worst days I've had was trying to convince myself that it is perfectly OK to take a hole saw at the end of an electric drill and bore a wee-bit-larger hole in the floor of my boat so that the transducer would fit. I had to be sedated afterwards, but it worked out.
Next trick, then is to be sure you get the epoxy resin in the hole with no bobbles when you lay the transducer in. After than, covering the unit with the resin was pretty easy. Good luck, m
That was a hoot to read. Please tell me this was a joke, right...?? |
|
| |
