|
|
Location: Northern Illinois | Anyone have any tips on how to epoxy a humminbird 2D shoot thru hull transducer on a ranger 681vs |
|
| |
|
Posts: 44
| Use a ziplock bag with water in it and no air bubbles, place the transducer on it to make sure it reads good. once you have a good location epoxy it in. Make sure its a slow cure epoxy.
Ryan |
|
| |
|
Posts: 100
| I sanded the fiber glass area a bit before I applied epoxy. I filled my boat with enough water to cover transducer and put a bag of sand on top. Then drove around a bit to find best location. It is really pretty simple. |
|
| |
|
Location: Northern Illinois | Okay thanks. So I fill boat with water enough to cover transducer then take it out on the water and see best reading area? |
|
| |
|
Posts: 482
| i did it on monday on the water without any water in the boat and works good
Edited by danlaboucane 6/22/2017 7:11 AM
|
|
| |
|
Posts: 100
| I kept the transducer in the water so no air would be between the hull and transducer |
|
| |
|
Posts: 482
| ok i understand |
|
| |
