MuskieFIRST | Tuffy esox filler » Muskie Boats and Motors

Muskie Discussion Forums

You are logged in as a guest. ( logon | register )

Moderators: Slamr	View previous thread :: View next thread
Jump to page : 1 Now viewing page 1 [30 messages per page] Muskie Fishing -> Muskie Boats and Motors -> Tuffy esox filler

Message Subject: Tuffy esox filler

thescottith

Posted 9/2/2016 1:33 PM (#829300)
Subject: Tuffy esox filler

Posts: 444

I removed the old lowrance GPS puck from the back of my esox mag. It was mounted above all the gauges. I know have two small holes in that non-carpeted area.
What should I fill these holes with?

Thanks

SK

sworrall

Posted 9/2/2016 4:21 PM (#829323 - in reply to #829300)
Subject: Re: Tuffy esox filler

Posts: 32802

Location: Rhinelander, Wisconsin

Where was it mounted? On the top of the instrument panel flat? high quality epoxy will work, but if it's in an area where you want it to look good and the surface is gel coated, you can match the gel coat and patch it up.

thescottith

Posted 9/2/2016 4:39 PM (#829327 - in reply to #829300)
Subject: Re: Tuffy esox filler

Posts: 444

Yes it was on top of the instrument panel, i would just like to fill it to prevent water from getting in. Not really worried about it looking nice as the holes are pretty small.

sworrall

Posted 9/2/2016 9:50 PM (#829352 - in reply to #829300)
Subject: Re: Tuffy esox filler

Posts: 32802

Location: Rhinelander, Wisconsin

A bit of quality quick cure epoxy in each.

esox1980

Posted 9/3/2016 7:50 AM (#829365 - in reply to #829300)
Subject: Re: Tuffy esox filler

Posts: 265

Location: Manitowish Waters WI

I put a couple of Team Rhino stickers over my puck hole. Only have about 15 of them from my online orders. Holds up fine

John23

Posted 9/4/2016 10:37 AM (#829420 - in reply to #829300)
Subject: RE: Tuffy esox filler

Posts: 46

I had a good experience with Marine-Tex epoxy in a similar circumstance.

Jump to page : 1
Now viewing page 1 [30 messages per page]

Search this forum
Printer friendly version
E-mail a link to this thread