Muskie Discussion Forums
| ||
Moderators: Slamr | View previous thread :: View next thread |
Jump to page : 1 Now viewing page 1 [30 messages per page] Muskie Fishing -> Muskie Boats and Motors -> Trailer Lights? |
Message Subject: Trailer Lights? | |||
kdebell |
| ||
Posts: 251 | I am having a problem with my trailer lights. The are all getting power but my right turn signal is not work. Used a light test and everything but the right signal is getting power. Any suggestions as to what is going on or how it can be fixed? Thanks Edited by kdebell 4/28/2015 3:30 PM | ||
BLIZZAK |
| ||
Posts: 255 | probably a broken wire or bad wire connector. Start from plug and chase the wire back with a test light | ||
DonPursch |
| ||
Posts: 540 Location: Leech Lake, Walker MN | May also check your ground on that side . | ||
Chemi |
| ||
Assume you checked the bulb? | |||
ToddM |
| ||
Posts: 20180 Location: oswego, il | Where are you getting power at the light or trailer plug? Bulb or led lights? From where you have power to the light you have a problem. Tail lights have two filament, one for brake another for turning. If it is an led light you will need to replace.the light. | ||
kdebell |
| ||
Posts: 251 | I am getting power at the plug that is connected to the truck going into the trailer. I have a feeling that something isn't connected right seeing that I just replaced the lights from bulb style lights to LED's. I am not sure why I am getting brake lights but no turn signal. Should I re-wire the side with the problem? | ||
kdebell |
| ||
Posts: 251 | I also do not have a break light on the same side. When I turn the lights on, the light on the right side does work. | ||
ToddM |
| ||
Posts: 20180 Location: oswego, il | Check your connection for the brake/signal wire at the light. Sounds like that is where your problem most likely is. | ||
jchiggins |
| ||
Posts: 1759 Location: new richmond, wi. & isle, mn | I'm assuming you have a newer vehicle with a six pin connector. If so, find the ten amp fuse for the side that's out. Probably marked ( TRL BRAKE LT) for brake and left turn on your trailer circuit. Each circuit on your six pin has its own fuse. Edited by jchiggins 4/28/2015 7:23 PM | ||
Fishen-ski's |
| ||
Posts: 140 Location: Northern Illinois | Is your truck engine running when you test the signals? My set-up only works right if the motor is running. | ||
kdebell |
| ||
Posts: 251 | Thank you for all the help. Whoever rigged the lights before me had two connections between the plug and the wire. The green wire was broke in this section. | ||
Jump to page : 1 Now viewing page 1 [30 messages per page] |
Search this forum Printer friendly version E-mail a link to this thread |
Copyright © 2024 OutdoorsFIRST Media |