Posts: 2280
Location: Chisholm, MN | Brad P - 3/21/2017 7:37 AM
That is basically the boat I run.
2.) The rear panels on the back casting deck are hollow. You can remove the front of the one on the port side. I ditched the stock rod straps and installed the Rod Saver vertical holders (they have a rubber attachment) and installed them horizontally. Then I used a 3M super adhesive spray and a piece of neoprene foam I ordered on line, which was attached to the transom. This results in rod storage that will easily store 5+ 9' musky rods. When I do family trips I've had as many at 12-13 rods stacked and stored in here. (I wouldn't put that many in there while fishing.)
Interesting Brad. Could you post a picture of this? I'll have to look at my boat when I get home.
Edited by Kirby Budrow 3/21/2017 12:36 PM
|