|
| take the head off the terrova by removing 4 screws, remove the bolt and nut below the head as well.
Pull the shaft through the mounting unit and lay the motor and shaft on a table, use Dow 5200 adhesive and glue the transducer wire into the channel in the shaft. use tape to hold the wire in place until it cures, allow at least 48 hours in 70+ temp for curing.
Remove tape from shaft and run end of transducer wire through mount unit then push shaft back into place. put a round or two of tape around wire at the base of the shaft and replace the head on the unit.
This keeps the wire completely out of the way and is very simple to do. | |
|
