Post a message

Muskie Discussion Forums

Search | Statistics | User Listing

You are logged in as a guest. ( logon | register )

Posting a reply to: RE: transducer mounting on a terrova

Muskie Fishing -> Muskie Boats and Motors

You are replying to:

DocDean

Posted 5/16/2009 11:45 AM (#378625 - in reply to #374484)
Subject: RE: transducer mounting on a terrova

Hey Guys,

Theren is a simplle solution that has worked great for me for two years now.
The flat metal tensin tab that comes in contact with the horizontal locking pin.
Tha picture above shows it real well. Anyways make a loop with azip tie with an openining about large enough ti put the end of your thumb through. Have this loop secured around the flat metal spring tap and run your cord from the transducer through this loop. Secure the cord at the base of the head using aanther large zip tie and or tape. I also put a rubber sleeve around the actual transducer cord to help from getting the insulation cut. Just make sure to leave enough slack foer full rotation of the trolling motor head. I then ran the cord back down to the base through the center of the coiled cord. and secured near the base. Has worked perfect for me and no chance of trapping the cord in the deploying mechanism.

Hope you can picture what I've said
Dean