Muskie Discussion Forums

Forums | Calendars | Albums | Quotes | Language | Blogs Search | Statistics | User Listing
You are logged in as a guest. ( logon | register )
Posting a reply to: Help!!! Outboard issues

Back
Muskie Fishing -> Muskie Boats and Motors
Guest name
Subject
Message

Emoticons
HTML: Yes
Anonymous: Yes
MBBS Code: Yes


Disable HTML
Post anonymously
Enable emoticons



hi


You are replying to:
derekrusty
Posted 11/8/2017 8:54 PM (#883800)
Subject: Help!!! Outboard issues





Posts: 186


Location: Waconia, MN
Hello, quick troubleshooting question. I took my boat out today for one last fishing trip. I have a 40 horse power Mercury magnum 2 stroke, 1995. It took a little bit longer to start up today but I just assumed that was because it was really cold. The motor ran like it normally does for about 2 minutes and then it started to sound a little different. Over the course of the next 45 seconds it began to run rougher and rougher until it finally turned off. I had the boat out about 2 weeks ago and had no issues. So it hasn't been sitting for long. It has the same non oxygenated gas that I have always used and I didn't add any today. I know that I have enough gas and I know that my battery is good. At this point I can barely even get the motor to make a sound when I turn the key. Just a little jerk and clunk. I don't know if this means the motor is locked up or not. I have noticed a little bit of oil leaking over the last few months but not a whole lot. The motor has an oil injector and I am wondering if somehow that is not functioning correctly. I did swap out the spark plugs and that didn't make a difference. Any thoughts as to what this could be? I am just looking for a little peace of mind hopefully. I am going to get it into the shop sometime this week but it is driving me nuts not knowing. Any ideas or advice would be greatly appreciated, thanks!

(Delete all cookies set by this site)