|
|
Posts: 163
Location: NoDak | here is my short boat rebuild, modified for bass and musky! dam i am excited!
just need to make some base boards, install the graphs and get the windsheild on.
Edited by samuwenn 5/12/2014 12:40 AM
Attachments
----------------
 ,mmm.jpg (92KB - 139 downloads)
,mm.jpg (75KB - 150 downloads)
,m.jpg (79KB - 151 downloads)
a1.jpg (73KB - 148 downloads)
a3.jpg (83KB - 142 downloads)
a2.jpg (80KB - 149 downloads)
0000.jpg (156KB - 154 downloads)
|
|
| |
|
Location: Waukesha, WI, USA | Nice job |
|
| |
|
Posts: 139
Location: Aurora IL | Looks nice. one question, is that a removable base for drivers seat? I believe by CG regs must be permanent but may not apply to rebuilds. How long of rod lockers were you able to fit. Bill |
|
| |
|
Posts: 163
Location: NoDak | Rod locker is greAter than 10'5" and as far as CG standards go I guess I know it has more foam in it than original and the boat came with the remove able seat base for driver and never considered that it may be wrong nowadays there has never been a check for anything like that up here in ND and have never seen MN DNR yet |
|
| |
|
Posts: 1276
Location: Walker, MN | It looks like you put a lot of work into that boat and it looks great! Thanks for the pics and report, would love to hear how it fishes. |
|
| |
|
Posts: 163
Location: NoDak | would be in it rite now, but the trailer had more than a bearing issue, it needed parts for the breaks, there ordered, will be out tomorrow afternoon and i am chomping at the bit |
|
| |
|
Posts: 270
Location: SE WISCONSIN | very nice build |
|
| |
|
Posts: 1516
| That looks nice. Did you use marine grade plywood? If so where did you fid it? |
|
| |
|
Posts: 163
Location: NoDak | Yes 3/4 marine at menards, but I also sealed it all with a product called C.P.E.S. Clear penetrating epoxy sealant... Then fiberglass matting and cloth resined in
Rotdoctor.com old school website but good products |
|
| |
|
Posts: 76
| Great job! It will be like having a new woman! Finished mine a year ago this week. $6000 and a little (lot) of elbow grease instead of $40,000 for a new one. Now to get some slime on her. Enjoy!!! |
|
| |
|
Posts: 163
Location: NoDak | fishes awesomely! i love IPILOT LINK!
|
|
| |
|
Posts: 121
| Nice job! |
|
| |
|
Posts: 7
| Great job! Looks fantastic |
|
| |
