|
|
Posts: 311
Location: Lake St.Clair | Is there anyway i can buy the hs gears from a 50 and put them in my 51?
Assuming I cant because of the diffrent handedness. Any input would be greatly appreciated.
Looked at the diagrams and did some searchs but couldn't find much.
Thanks
Troy |
|
|
|
Posts: 1141
Location: NorthCentral WI | No, you cannot. The gears would be mirror images of each other. |
|
|
|
Posts: 245
| You can use gears from a Toro HS 51, i did and it works great
Theres a JDM (Japanese Models) Toro with 7.1:1 gears though, would make a sweet bucktail reel |
|
|
|
Posts: 311
Location: Lake St.Clair | MuskieSwede - 10/24/2013 2:49 PM
You can use gears from a Toro HS 51, i did and it works great
Theres a JDM (Japanese Models) Toro with 7.1:1 gears though, would make a sweet bucktail reel :)
Now were talkin might have to give that a go. Do you by chance remeber were you ordered them?
Pretty simple install I imagine keyword imagine. |
|
|
|
Posts: 2894
Location: Yahara River Chain | Gear swap was discussed a little while back like last May or June. |
|
|
|
Posts: 2894
Location: Yahara River Chain | Found it..... try this link
http://muskie.outdoorsfirst.com/board/forums/thread-view.asp?tid=85... |
|
|
|
Posts: 311
Location: Lake St.Clair | I tried searching before I posted just didn't use winch in the search.
I ended up with scattered results with no real conclusion guess ill compare part numbers from the NaCL to the toro and go from there.
Thank you
Troy
|
|
|
|
Posts: 245
| I just orderred from Abu
You need the main gear, the pinion gear. Then depending on if it's the first or second generation Toro HS gears (i dont know how to check that) you might need the drag washers and metal bushings. |
|
|
|
Posts: 2894
Location: Yahara River Chain | As stated in the other thread, you need to compare the other components around the main and pinion gears making sure the the one you have matches the one on the HS model. You should only have to replace the main and pinion gears and maybe the yoke. When you call Abu, make sure you have your reel in front of you and able to tell them what model you have and what you plan to do. I'm sure that they could do it, but it takes some time to eliminate this or that model to find the right one where you can just swap out the gears.
Note - drag washer parts should be the same in both models. . |
|
|
|
Posts: 339
Location: Denmark | MuskieSwede - 10/25/2013 1:11 AM
I just orderred from Abu
You need the main gear, the pinion gear. Then depending on if it's the first or second generation Toro HS gears (i dont know how to check that) you might need the drag washers and metal bushings.
ABU has the scematics here,
http://www.abugarcia.com/support/reel-schematics?field_schem_numb_v...
you can match the scematics to the reels, by checking the code(number) under the reel foot. First and second gen gears has different part numbers.
|
|
|
|
Posts: 245
| You are absolutely right Killerbug |
|
|