|
|
Posts: 260
Location: Almost Heaven | Where is a good place to get the replacement squirrely tails and the cork screws to fasten them to for hard baits? Thanks guys | |
| | |
| You can easily make the 'cork screws' yourself out of single strand stainless leader wire or welding wire - just need a pair of round nose pliers and a bit of practice. Cut the leading end at an angle to get a point that'll twist in easily.
For the other end that fits into the bait just do a tiny loop (and squash it a bit if necessary) and epoxy it in.
Regards,
Mark | |
| |
|
TAILS AND SCREWS