|
|
| 
 
  
 
 Posts: 19
 
 
 Location: Lake St.Clair
 | Hello, 
 Recently while fishing I had a snag and when trying to release the spool the thumb bar release cracked. Now it is stressed and does not release easily due to the fracture in the plastic. I tried looking for the part # in the schematic but can't seem to find it. Any help would be appreciated. There is a part # for the thumb rest on the top of the can though. I put a picture up of the fracture as well.
 
 Also, does anybody recommend a source to order the part from?
 
 Thanks
 
 
 
 
 
 
 
 
 
 
 
 Attachments
 ----------------
 
  P1110383.JPG (148KB - 232 downloads) 
  P1110384.JPG (128KB - 223 downloads) 
 | 
|
|  | 
|
| 
 
 
 Posts: 1753
 
 
 Location: Mt. Zion, IL
 | I would epoxy it and hope it holds.  Garcia does not sell just the thumb bar.  You will have to buy a complete frame and they run about 55 dollars. | 
|
|  | 
|
| 
 
 
 Posts: 115
 
 
 
 | try daves reel service, he carries thousands of parts and just might have one in stock. | 
|
|  | 
|
| 
 
  
 
 Location: Latitude 41.3016    Longitude 88.6160
 | I have one email for info    $15.00 cost plus shipping I stock ABU, SHIMANO, and DAIWA parts.
 [email protected]
 | 
|
|  | 
|
| 
 
 
 Posts: 1753
 
 
 Location: Mt. Zion, IL
 | PIKEMASTER - 11/12/2012  10:12 PM  
I have one email for info    $15.00 cost plus shipping   
I stock ABU, SHIMANO, and DAIWA parts.  
[email protected]
 How do you remove the frame pin to install the thumb bar?  Isn't it brazed to the sides of the frame?
 | 
|
|  | 
|
| 
 
  
 
 Location: Latitude 41.3016    Longitude 88.6160
 | RyanJoz - 11/13/2012  7:18 AM  PIKEMASTER - 11/12/2012  10:12 PM  
I have one email for info    $15.00 cost plus shipping   
I stock ABU, SHIMANO, and DAIWA parts.  
[email protected]
How do you remove the frame pin to install the thumb bar?  Isn't it brazed to the sides of the frame?Your right U can't remove that to replace it
 I have a Frame with the thumb bar for $15.00 plus Shipping
 | 
|
|  | 
|
| 
 
  
 
 Posts: 19
 
 
 Location: Lake St.Clair
 | Thank you everyone for the responses. I just JB welded the piece and seems like it's going to hold up. Thank you for the offer Pikemaster, if it fails, I will be sure to contact you
   
 Aaron
 | 
|
|  |