Plastic Question
Juhas
Posted 1/16/2012 4:13 PM (#533281)
Subject: Plastic Question




Posts: 431


Pouring in an open top mold, not injection. Noticed that the plastic shrinks down a lot. Is this from trying to cool the plastic to fast?
Thanks
Chris
jdsplasher
Posted 1/16/2012 5:32 PM (#533293 - in reply to #533281)
Subject: RE: Plastic Question





Posts: 2270


Location: SE, WI.		Its just the natural reaction that the plastic does. If you need to keep mold full as plastic sets up...Keep dribbling plastic in the middle of mold to keep it from shrinking too much!