|
|
Posts: 70
| i have used my jointed outcast strictly for casting ,with min time on the water
i noticed the other day that the tail part of the bait is coming undone. the screw is actually loose in the bait to the point of coming out if i hook a med fish
this bait has only hooked into 1 fish and might have 8 hrs total time casting
anyone else have this problem , better to check your bait.
it was purchased spring 2010.
what would the repair be ?? i like the action of the bait and the attention it gets so a repair is a must for me also the cost
thanks bob | |
| | |
Posts: 431
| Take the screw eye out, fill the hole with epoxy, re-insert screw eye, let epoxy cure. I did the same thing to mine, I doubt the tail section will be going anywhere anytime soon. Mine is an older model that's got a bit of water time. Wish I had the bucks to buy a few more and have them custom painted. | |
| | |
Posts: 100
Location: W-PA | Give Brian a call and let him know your problem. 724-465-0502 | |
| | |
Posts: 212
| unscrew it partially, add Zap-a-gap super glue to the threads and rescrew. Make sure you get it straight cause it won't be moving again. | |
| |
|
legend outcast problem