|
|
Posts: 665
Location: Twin Cities, MN | Ok, I am now making the leap to try and tye my own flasahabou tails.
I have a good handle on where to get the flashabou and other components, but any tips or tricks would be appreciated, especially if you use a tying vise, or if you get by with something different.
Thanks.
Pal |
|
| |
|
Posts: 613
Location: big cove tannery pa | Do a search on tying flashabou and you should get plenty of info. |
|
| |
|
Posts: 665
Location: Twin Cities, MN | Thanks, yes, I was mainly trying to get an idea if people are using a tying vise, or perhaps using something else. |
|
| |
|
Posts: 335
Location: Minnesota | I bolted a tying vise onto my work station. I cut a length of coil and on the end of the coil, I bend it so that there is a tag end sticking out 90 degrees from the coil. I place that in the vise and lock it in tight, then start tying. You can cut that tag off if you want but I just leave it on and use it as a built in spacer on my coils. |
|
| |
|
Posts: 665
Location: Twin Cities, MN | Thanks, that is a good tip
Pal |
|
| |
Tying your own flashabou tails