|
|
Posts: 3160
| I have a two piece graphite rod that is stuck wont come apart any tips for loosening it,,,I tried WD 40 |
|
| |
|
Posts: 144
Location: the Netherlands | Tried WD 41 ?? nag nag.
if you are with 2 people try twisting it under running hot water and i mean HOT.
good luck.
Richard
|
|
| |
|
Posts: 576
Location: nappanee IN | put the rod behind your knees and grab hold of the rod with both hands and use the leverage from your legs and spread your legs the same time you pull with your hands, works for me on my 1 2-piece rod that i own..karol |
|
| |
|
Posts: 3915
| Here's a trick to make sure two pieces don't get stuk.....
twist the male end of the two piece against the place where your nose meets your cheek. There's oil in them tar pores. Works. |
|
| |
|
Location: Athens, Ohio | My dad would always run the rod ferrel thru his hair to pick up the oil (and Vitalis?) from the hair before sticking the two ends together. m |
|
| |
|
Posts: 2894
Location: Yahara River Chain | Hey Mikie does that also work with your Grecian Formula 16???? 
Edited by muskie! nut 6/9/2008 11:17 AM
|
|
| |
|
| Ice it down until you're sure the rod is cold the whole way through. Then get the rod in a position where you can pull it apart and use a hair dryer or heat gun to apply heat to the joint. The outside piece will expand first and if you're pulling the pieces apart when that happens you should be able to get them apart. |
|
| |
how to unstick a 2 pc rod????