Cv-z Repair??
Heikinheimo
Posted 12/9/2006 3:30 PM (#224646)
Subject: Cv-z Repair??




Posts: 15


Location: Litchfield MN		My CV-Z has some issues whit the drag it dosen't tighten down enough anymore and its not smooth at all. It whuld not be a problem fixing it my self but opening the reel recuires a very special/specific tool that you cant buy (i think). So i whas wonderin where you can send it for repair that wont take 6months.

Thanks

Niklas

Edited by Heikinheimo 12/9/2006 6:22 PM
jclymer
Posted 12/9/2006 4:32 PM (#224653 - in reply to #224646)
Subject: RE: Cv-z Repair??


Sent mine back to Daiwa in California..
vanertski
Posted 12/10/2006 8:39 PM (#224815 - in reply to #224646)
Subject: RE: Cv-z Repair??




Posts: 80


Location: Clintonville, Wi		Heikinheimo,

if you use a very small straight screwdriver, there are small slotted imbedded screw i think only two of them, loosen them and you will be able to access the guts of your reel.

Jeremy Van Ert
www.beastteaser.com
Unregisterd Heikinhe
Posted 12/10/2006 10:06 PM (#224838 - in reply to #224815)
Subject: RE: Cv-z Repair??


Ok thanks ill try that.

Niklas
RIck
Posted 12/16/2006 1:45 AM (#225970 - in reply to #224646)
Subject: RE: Cv-z Repair??


Send it to Chuck Brod. He is a guru in the musky reel service/repair industry. I have a cvz that he worked on a few times to address an anti reverse problem....Daiwa is actually swapping it out for a luna for me.

Here's chuck's link....

http://www.sportsmansrepair.com/