|
|
Posts: 102
Location: Ireland | I have a 10" Jake with a broken diving vane . I want to replace this for a new one . Any ideas on how to remove the damaged vane cleanly so as to replace it with the new one ?
|
|
| |
|
Posts: 166
Location: Gurnee, Illinois | If you have enough of the old lip to grab with pliers, you can try some heat and wiggle it loose. If that doesn’t work you’ll have to use a dremel tool or a file to grind out the old lip, being careful not to damage the slot the lip fits into. Just go slow and it’s pretty easy. |
|
| |
|
Posts: 102
Location: Ireland | Thanks for that ............ I`ll try the heat treatment first .. |
|
| |
|
Posts: 82
| If there is any lip left to grab try that first to break the glue or hold the lip in a vice and try the same. Once you feel the glue is cracked hold the bait in a vice with fibre vice grips just don't do it up murder tight, grip the flat edges of the Jake's body and with a small chisel or punch gently tap down evenly on both sides of the lip taking turns. It takes time but you have to "crack" the glue and it should drive out, some just won't budge and then its the laborious task of cutting and filing. |
|
| |
|
Posts: 1901
Location: MN | Where are replacement lips available? |
|
| |
|
Posts: 1276
Location: E. Tenn | https://www.driftertackle.net/shop/musky-mania/jake-lips/ |
|
| |
|
Posts: 102
Location: Ireland | Yeah , thats where I got mine ... I got the 10" one , though comparing it to the 8" jakes I already have , they seem to be the same size ! |
|
| |
|
Posts: 309
Location: Elgin IL | Drill a small hole in the broken lip screw in a small screw and wiggle out |
|
| |
|
Posts: 102
Location: Ireland | I used a heat gun to try and melt the glue around the lip , went too hot and lip started to deform ! Back to easy and slow and the lip came slightly loose and broke off at the nub of the lip on the inside of the lure . Used a 5mm drill bit to scope out the remnants of the nub from inside the lure . Did some smoothing and filing and slotted the new lip into place with superglue . Tested it out on a fishing trip before xmas , tracking slightly to the left but a bit of tweaking to the lure eye and we`re good to go . Trolls fine up to 3mph . Thanks for your advice . HNY , Pat |
|
| |
|
Posts: 41
| Dig into that toolbox (A.K.A. Wallet) and buy a new one |
|
| |
|
| they are cheap,if i would be you i would buy a new one,did you caught big pike at ireland with 10 inch jake? |
|
| |
|
Posts: 102
Location: Ireland | Money is not the problem !
I already have 3 other 10" Jakes . But just hate to see a lure go to waste for the sake of a simple fix .
Tbh I find the 8" jakes better for more and bigger fish . |
|
| |
10" Jake repair?