|
|
Posts: 1887
Location: syracuse indiana | hey guys . I have a question about my ct 400 b's 2 of them are having the pawl cap that are plastic. cracking and I need to replace them.. and I see that I can get the metal ones too are they the same for the ct 400b plastic ones.. will the metal ones work.. if so I will order 10 of those for my reels.. just asking before I get the plastic ones that will go bad again and metal will hold up
|
|
| |
|
Posts: 39
Location: Lawrenceburg,IN | Yes they will work. Call Shimano
|
|
| |
|
Posts: 1887
Location: syracuse indiana | cool thanks
|
|
| |
|
Location: Latitude 41.3016 Longitude 88.6160 | Also makes you replace the spacer washer with them
|
|
| |
|
Posts: 1887
Location: syracuse indiana | OH SHUTE I DIDNT KNOW THAT AND I ALREADY ORDERED THEM they are being shipped here already.. great
the site told me that they were optional for the BNT0060 spacer
https://fishshop.shimano.com/vip/product_detail.jsp?PRODUCT<>p... |
|
| |
|
Location: Latitude 41.3016 Longitude 88.6160 | When you install the Level Wind Pawl
If there is any space on top you need that washer spacer
Or the pawl will fail faster under load.
|
|
| |
|
Posts: 1901
Location: MN | Bill give me your address I'll stick a couple in the mail to you |
|
| |
|
Posts: 1887
Location: syracuse indiana | Thanks Propster, your the man let me know what I owe you. and its
William Bennett
715 w Portland st
Syracuse ind 46567
and thank you.. I ordered 9 of them.. my older ct400's had the old plastic cap on them and I am putting on the new metal caps
|
|
| |
|
Posts: 1901
Location: MN | Not sure I have that many but I'll send a few to get you started. You can also just cut out a small thin piece of plastic to fit in there |
|
| |
|
Posts: 1887
Location: syracuse indiana | Ok thanks |
|
| |
|
Posts: 528
| Using a paper punch on the thin plastic sheets like stencils to make a spacer would likely work. |
|
| |
Shimano CT 400 b pawl question