|
|
Posts: 444
| I removed the old lowrance GPS puck from the back of my esox mag. It was mounted above all the gauges. I know have two small holes in that non-carpeted area.
What should I fill these holes with?
Thanks
SK |
|
| |
|
Posts: 32934
Location: Rhinelander, Wisconsin | Where was it mounted? On the top of the instrument panel flat? high quality epoxy will work, but if it's in an area where you want it to look good and the surface is gel coated, you can match the gel coat and patch it up. |
|
| |
|
Posts: 444
| Yes it was on top of the instrument panel, i would just like to fill it to prevent water from getting in. Not really worried about it looking nice as the holes are pretty small. |
|
| |
|
Posts: 32934
Location: Rhinelander, Wisconsin | A bit of quality quick cure epoxy in each. |
|
| |
|
Posts: 265
Location: Manitowish Waters WI | I put a couple of Team Rhino stickers over my puck hole. Only have about 15 of them from my online orders. Holds up fine |
|
| |
|
Posts: 46
| I had a good experience with Marine-Tex epoxy in a similar circumstance. |
|
| |
Tuffy esox filler