What Size Double Barrel Crimp for 130lb Fluro
Slamr
Posted 6/12/2016 7:02 AM (#820284)
Subject: What Size Double Barrel Crimp for 130lb Fluro





Posts: 7049


Location: Northwest Chicago Burbs		Just about ready to finally start making my own leaders...what size double barrel crimp sleeve deal do I need?
BNelson
Posted 6/12/2016 7:58 AM (#820287 - in reply to #820284)
Subject: Re: What Size Double Barrel Crimp for 130lb Fluro





Location: Contrarian Island		1.3 mm
lifeisfun
Posted 6/12/2016 9:11 AM (#820292 - in reply to #820284)
Subject: Re: What Size Double Barrel Crimp for 130lb Fluro





Location: Ontario		I asked this question about a month back in the thread about crimping leaders, there was no answer at that time- Thanks BNelson!
Is there complete table somewhere about sizing?
kirkkopplin
Posted 6/12/2016 9:28 AM (#820295 - in reply to #820284)
Subject: RE: What Size Double Barrel Crimp for 130lb Fluro




Posts: 245


Location: Madison		check out www.leadertec.com lot's of good info and supplies.
lifeisfun
Posted 6/12/2016 9:41 AM (#820297 - in reply to #820284)
Subject: Re: What Size Double Barrel Crimp for 130lb Fluro





Location: Ontario		^Thanks
Zib
Posted 6/13/2016 7:58 AM (#820386 - in reply to #820284)
Subject: RE: What Size Double Barrel Crimp for 130lb Fluro





Posts: 1405


Location: Detroit River

I use the Hi-Seas size "C" for 130 LB.

 

BNelson
Posted 6/13/2016 8:40 AM (#820390 - in reply to #820284)
Subject: Re: What Size Double Barrel Crimp for 130lb Fluro





Location: Contrarian Island		hi seas 1.3 mm are perfect for 130 lb.... for 180 use 1.6 mm...can get 100 on ebay for about 8 bux
for anything under 130 I use the same 1.3 mm..they are a bit bigger but the 1.0 mm ones are narrower so your crimper is over both ends which is not preferred so I use the 1.3 mms for say 100 lb if I ever use that which is about never
toddb
Posted 6/14/2016 9:51 AM (#820557 - in reply to #820390)
Subject: Re: What Size Double Barrel Crimp for 130lb Fluro





Posts: 379


Location: Thief River Falls MN		I would look into the Jinkai Aluminum sleeves. LI would be the size for 130#. Have had great success over the years. Initial cost for SC-2C or SC-3 crimping pliers is about $40 but it is a nice tool that will last forever.