|
|
| Hey all, it’s been a while since I’ve posted anything. That’s because my shop has been packed up for the last year and a half. I’m finally setting up shop again and can’t wait to start making lures. Well my lure spinner did not fare the move very well and it was time to rebuild it anyway. I just finished my plans for a new one and thought I’d share them here in case it’s helpful to anyone.
Edited by MRichardson 1/14/2015 12:53 PM
(Lure Spinner motor assy.jpg)
Attachments
----------------
 Lure Spinner.jpg (49KB - 541 downloads)
Lure Spinner motor assy.jpg (77KB - 545 downloads)
|
|
| |
|
| Thank you for sharing.
Scott |
|
| |
|
| Mike,
Are you using a threaded rod for a reason. Are the holes in your wheels threaded?
Thanks,
Scott |
|
| |
|
| Wow. Now that's planning! |
|
| |
|
| Yes for a reason, first they are cheaper than drive shafts and will fit in the bearings good enough, but mainly I’ll use 3/8 nuts to jam secure the two plates or whatever other attachments I might want to have on the shaft. |
|
| |
|
Posts: 496
| Mike Thanks for that , glad to see you are getting back up and running . Been wanting to redo my spinner , so that gave me some ideas .
|
|
| |
|
Posts: 1202
Location: Money, PA | Welcome back Mike! |
|
| |
|
Posts: 1
| Another option is the one used in the movie i'm linking to, just watch the last 10 seconds.
I think it's a smart solution
https://m.youtube.com/watch?v=8Vg_eUSxA8g |
|
| |
|
| I built the drying wheel last weekend; total build time was about a six pack. Here’s what it looks like.
Attachments
----------------
drying_wheel.jpg (79KB - 534 downloads)
|
|
| |
|
Posts: 496
| Mike, Whats the Buna n Spider thing do/for ? Looks great |
|
| |
|
| The buna spider is soft rubber and fits within the two couplings to absorb misalignment |
|
| |
|
Posts: 496
| Cool thanks . cant wait to see some baits on that thing |
|
| |
|
Posts: 403
Location: Lakeville, MN | Ive built a few of these
(IMG_20161001_092723.jpg)
(IMG_20161001_092835.jpg)
Attachments
----------------
IMG_20161001_092723.jpg (90KB - 469 downloads)
IMG_20161001_092835.jpg (105KB - 447 downloads)
|
|
| |
|
Posts: 102
| i just changed my spinner from a wheel to this cost is about $80 - $100 main cost is motor i spaced at 4" so i have 12 spots but you can move them in to 2" easily and would end up with 24 on a 3'-4' spinner
mike
Attachments
----------------
IMG_1058.JPG (112KB - 455 downloads)
IMG_1057.JPG (102KB - 476 downloads)
|
|
| |
|
Posts: 30
|
Hi,
What are you using to clamp the lure blank to the axle? |
|
| |
